Back to Blog
How-to Guides 2026-11-20 Zygo 0 views

Dual Stepnet Interface Board Replacement Guide

Dual Stepnet Interface Board Replacement Guide

Learn when and how to replace the Dual Stepnet Interface Board in your Zygo system. This guide covers compatibility checks, catalog identification, and installation steps.

What This Guide Covers

The Dual Stepnet Interface Board is a spare part designed for use with compatible Zygo equipment. This guide explains how to identify the correct replacement part, what the catalog confirms about it, and what steps you can take to ensure a successful installation.

This spare part is listed under the ZYGO brand with SKU 6450-0151-01, and it is available as a standard option. Before you begin, verify that your system requires this specific board.

Catalog Identity for the Dual Stepnet Interface Board

  • Dual Stepnet Interface Board: The Dual Stepnet Interface Board from Zygo is a spare part intended for use with compatible Zygo equipment. It is listed under the brand ZYGO and carries the standard SKU code 6450-0151-01. Matching the SKU and brand ensures you order the correct spare part for your system. The catalog confirms this board is a standard option, so no special variant is needed.
    Dual Stepnet Interface Board
    Dual Stepnet Interface Board

Pre-Installation Compatibility Check

The catalog states that the Dual Stepnet Interface Board is intended for use with compatible Zygo equipment. It does not list every compatible system model or revision. Before ordering, cross-reference your system's model number and existing interface board part number with the SKU 6450-0151-01.

If your current board has a different SKU or is from a different brand, the Dual Stepnet Interface Board may not be a direct replacement. Contact Zygo support or consult your system manual to confirm compatibility.

Installation Steps

The catalog does not include specific installation instructions for this board. The following steps are general best practices for replacing an interface board in compatible Zygo equipment. Always follow your system's service documentation.

  1. 1. Power down and disconnect: Turn off the system and disconnect it from power. If applicable, remove any connected cables or modules that might obstruct access to the interface board.
  2. 2. Locate the existing board: Open the system chassis according to the manufacturer's instructions. Identify the current interface board and note its mounting points and cable connections.
  3. 3. Remove the old board: Carefully disconnect any cables or connectors attached to the board. Remove any screws or brackets securing it. Lift the board out without forcing it.
  4. 4. Install the Dual Stepnet Interface Board: Position the new Dual Stepnet Interface Board (SKU 6450-0151-01) in the same orientation as the old board. Secure it with the original hardware and reconnect all cables.
  5. 5. Power on and test: Close the chassis, reconnect power, and power on the system. Verify that the system recognizes the board and that all connected interfaces function correctly.

What the Catalog Does Not Cover

The catalog confirms the board's identity and that it is a standard spare part, but it does not provide details on compatible system models, installation torque, or software configuration. If your system does not recognize the board after installation, check for firmware updates or contact Zygo support.

The Dual Stepnet Interface Board is priced at USD 4708.50 (catalog comparison price USD 6450.00). This price reflects its role as a specialized spare part for precision equipment.

Related Articles

Customer Service
Home
Products
Cart
Profile